Why a Buffer Is Mandatory Between Winding and Magnet Insertion: Jiuju's Line Balancing Approach
324定子绕线与转子插磁钢是两条不同的工艺链,节拍很少天生相等。中间不设缓存,整线产能被慢的一段锁死。
View Full Version匝间耐压不合格是Winding后常见不良,排查漆包线、张力与模具可快速定位根因。
波形出现明显衰减或震荡,说明绕组内部存在匝间短路或绝缘薄弱点。常见根因有三类:漆包线本身有针孔或漆瘤、绕线张力过大把漆膜刮伤、模具棱角锋利刮破线皮。我们产线曾有一批0.18mm线径的Product不良率突然升到3.5%,最后排查到是张力轮磨损导致张力波动超过±15%。

先看线材来料。把同一盘漆包线在实验室做针孔试验和漆膜连续性测试,如果每5米针孔数超过3个,优先换料。线材OK后再查设备:张力器设定值是否超过漆包线破断力的30%,过线轮和导针是否有毛刺,排线导程是否顺畅。模具方面,槽口倒角建议做到R0.3以上。

The pulse voltage is set to 2–3 times the motor’s rated voltage, with the rising edge controlled to within 1 μs; this makes the waveform more sensitive to minor short circuits. At the same time, a standard waveform template must be established by using the waveform from the first accepted unit as a reference, against which each subsequent unit is automatically compared for similarity. We generally set the similarity threshold at 85%; values below 80% are immediately judged as NG, while those between 80% and 85% are manually reviewed to avoid misjudging minor variations in normal windings as defects.

定子绕线与转子插磁钢是两条不同的工艺链,节拍很少天生相等。中间不设缓存,整线产能被慢的一段锁死。
View Full VersionJiuju Automation provides CNC motor winding machines and stator winding production lines suitable for brushless, servo, series-wound, and transformer coils, ensuring full slot fill and consistent turn-to-turn consistency.
View Full VersionJiuju Automation provides CNC motor winding machines and stator winding production lines suitable for brushless, servo, series-wound, and transformer coils, ensuring full slot fill and consistent turn-to-turn consistency.
View Full Version有刷直流电机在电动工具产线上的卡点是换向器压装后与碳刷的对位:压装曲线决定片间跳动,精车圆度决定碳刷接触面积,误差沿工序累加到同一圈接触面上。
View Full Version