Why a Buffer Is Mandatory Between Winding and Magnet Insertion: Jiuju's Line Balancing Approach
319定子绕线与转子插磁钢是两条不同的工艺链,节拍很少天生相等。中间不设缓存,整线产能被慢的一段锁死。
View Full Version电机装配线气密性测试影响IP防护等级,设置压力与时间参数是关键。
壳体焊缝、出线口、端盖与机壳配合面是最常见的泄漏点。特别是新能源驱动电机和水泵电机,客户通常要求IP67以上。我们去年验收的一条水泵电机线,把气密工位放在总装后端、涂装之前,测试压力设定为25kPa,稳压5秒后检测泄漏率,漏判率从之前的1.2%降到了0.15%。

一般参照ProductGenerally, the settings are based on the product standard, with an increase of 20%. For IP67 motors, the typical test pressure is 15–30 kPa, with a pressure hold time of 3–10 seconds; if the product requires IP68 or higher, it is recommended to increase the pressure to 50 kPa or higher and maintain it for 10–15 seconds. It is important to note that the housing temperature must be equilibrated with the ambient temperature; if the temperature difference of a housing that has just come off the welding station exceeds 5°C, testing errors may be amplified by a factor of three.

First, inspect the fixture O-rings once per shift and replace them immediately if worn; second, calibrate using a standard leak hole after each changeover; if the calibration deviation exceeds ±10%, shut down the machine to investigate; third, link the test data to the housing’s QR code to facilitate traceability. We generally use a three-tier classification system: if the leakage rate is less than 50% of the standard value, the product is released directly; if it is between 50% and 100%, it is marked for observation; and if it exceeds 100%, it is automatically rejected and sent to the maintenance station.

定子绕线与转子插磁钢是两条不同的工艺链,节拍很少天生相等。中间不设缓存,整线产能被慢的一段锁死。
View Full VersionA multi-pole architecture brings a high-frequency fundamental; at 10,000 rpm the fundamental frequency can reach several kHz. Traditional IGBTs suffer soaring switching losses and severe heating — it is the MHz-class switching capability of SiC MOSFETs that truly matches high-frequency multi-pole axial flux motors.
View Full Version选飞叉还是针式,先看三个参数:定子内径与槽口宽度、每槽匝数与线径、要求的槽满率。分界线只有一条——槽口能不能让针进去。
View Full Version减速电机异响要先分后合:电机段与减速箱段各自测,再合装整机跑合。三个噪声来源频段互相重叠,合装后只能得到一条总曲线,拆一次还要重新加脂跑合。
View Full Version